How does Yanhua ACDP do VW & Audi mileage correction?

Can Yanhua Mini ACDP supports to do VW/Audi gearbox mileage correction? The answer is yes. Only to have A605 License, by working with ACDP Module 13 or Module 21 to easily realize. Supports VW/Audi DQ200(0AM/0CM), DQ250(02E/0D9), DL382(0CK), VL381(0AW) mileage adjustment.

How to correct VW/Audi gearbox mileage?

Connect ACDP programmer to vehicle OBD port.

Mini ACDP>> VW >> Gearbox mileage correction >> Audi >> Detect module info

Connect ACDP with gearbox, click "OK".

Check gearbox info, it's DQ380(0DE).

Required Tools:

ACDP Programmer

SH725XX-0DE interface board

DB15LAN adapter

TCU cable

Connect the interface board.

Pull DB15LAN adapter's button to the CAN-R side.

Connect the power charge & vehicle gearbox.

DQ380(0DE) >> Mileage correction(auto mode) >> Continue

Check system info, original mileage:13608km

Click "Continue".

Save EEPROM data.

Enter new mileage: 6767km

Click "OK".

Ready to write chip data, please don't cut the power nor pull out the device during the programming!

Click "Continue".

Correct mileage finish.

How to correct system run time?

Time correction(auto mode) >> Continue

Check system info, system run time: 6666 hours.

Click "Continue".

Save EEPROM data.

Enter new run time: 1206hours

OK >> Continue

Correct time finish.

Check the correction info.

Identify >> Continue

System info have been changed:

Mileage: 6767km, system run time: 1206hours.

Done.

This is how to do VW/Audi gearbox odometer correction with Yanhua ACDP.

www.obdexpress.co.uk

Can Yanhua tools support 35128 chip?

 Hello everyone, I used Yanhua module 4 to erase the 35128 chip. Will red dots appear when erasing the chip data under normal circumstances?

Yanhua engineer replies: 35128 chip has two kinds of data (V1 and V2)

V2 can directly wipe data without red dots.

V1 cannot directly erase data, and the analog chip needs to be replaced. Users can use Yanhua 35XX programmer + Simulator to read and modify data with Yanhua Mini ACDP or Digimaster 3.

Thanks for the reply from the engineer, one more question: I put can file wrong, it jumped back mileage. Then i try make again, but cannot read or write. Can the simulator only change the mileage once?

Yanhua engineer replied:

The simulator can modify the mileage many times, but chip soldering is not an easy task. If the chip is soldered many times, the chip is easy to break.

It is recommended that you check whether there is a problem with the soldering of the chip. If there is no problem, you should consider whether the chip is damaged.

Technical support: obdexpress.co.uk