Tested successfully! Yanhua Mini ACDP is able to make new keys to Porsche 2010-2018.
Tool: Yanhua Mini ACDP + Module 10
Time: around 8 minutes
Step-by-step instruction:
Run Mini ACDP Porsche software
ACDP starts to add new keys to Porsche...
Add new key for new Porsche - ICP IMMO - MC9S12XEP100 (Mask 1N35H) - Add key (auto mode)
Note:
- Pls prepare OBP+ICP adapter, BCM interface board, BCM module, BAV adapter and blank key
- It is forbidden to cut ACDP power off during the process of adding a key
- Pls store the original and programmed EEPROM/DFLASH data as prompts.
Note:
- Pls connect ACDP device, OBP+ICP adapter, BCM interface board, BCM module
- Check the crystal oscillator package of BCM module: EXT1 short - circuited for ceramic packaged crystal oscillator, EXT2 short-circuited for metal packaged crystal oscillator
- Save the chip data read by the BCM module according to the software tips
Pin detection status:
When EXT contact is bad, check the EXT1 pin if the crystal oscillator is ceramic packaged or EXT2 pin if it’s metal packaged
It’s detected that the BCM module chip has been encrypted. Continue
Read PFLASH, EEPROM/DFLASH data and save data
Immo information:
Pls make sure the info is correct
Note:
- Keep the ACDP device power on
Disconnect the OBP+ICP adapter and ACDP device firstly. (Keep the OBD+ICP adapter, BCM interface board and BCM module connected)
- Connect the ACDP device to the BAV-KEY adapter and put the key correctly in the BAV-KEY adapter
ACDP read out the current key ID
Select a number for adding a key
(the gray number is not optional, that mean this key number is already used or current key is already exit)
Mini ACDP is rogramming key...
Store DFLASH data
Note:
- Keep the ACDP device power on
Disconnect the OBP+ICP adapter and ACDP device firstly.
- Connect the ACDP device, OBD+ICP adapter, BCM interface board and BCM module
- Check the crystal oscillator package of BCM module: EXT1 short - circuited for ceramic packaged crystal oscillator, EXT2 short-circuited for metal packaged crystal oscillator
Pin detection status
It’s detected that the BCM module chip has been encrypted
Check the key information
Adding key completed
Pls install the BCM module back to the vehicle to confirm that the new key can be used normalyy
Success
No comments:
Post a Comment